Skaz Posted December 1, 2015 Share Posted December 1, 2015 Hi, I'm loosing my mind on El Capitan installation! I tried these two different ways: 1- With Chameleon Enoch-2795, but no way to reach the installation, I have this message when I launch it: PCI0_UID patched to 1 in the dsdt table Error: rsdp_mod size is incorrect 2- With Clover, the installation went to the end, and asked me to restart. I restart on my working 10.10 system which is on a different HDD for proceed to the Clover 3320-legacy and essentials kexts installation. But when I restart for the first launching, the HDD where I just installed El Capitan is not even listed on the Clover menu, like there is no system at all. I also noticed something that can be connected to the Clover issue. When I try to repair permissions with "Disk Utility", I get the message you can see on the attached file. Thank you for your help Link to comment Share on other sites More sharing options...
Skaz Posted December 3, 2015 Author Share Posted December 3, 2015 Nobody for little help or suggestion please? If Yosemite work just fine, El capitan should too, right? Link to comment Share on other sites More sharing options...
Skaz Posted December 21, 2015 Author Share Posted December 21, 2015 So, I finally succeed the 10.11.2 installation. The message error was because of the chameleon modules (ACPI or Sata I guess) I just let FileNVRAM. And the installation and reboot goes well. All work fine Link to comment Share on other sites More sharing options...
Recommended Posts