luppolone Posted September 19, 2014 Share Posted September 19, 2014 Hello everyone.I have some problem with post installation on Maverick. My setup is as follows:- AsRock Z77 Extreme4- I5 3570k- AMD HD 7950- 8 Gb Ram Corsair Vengeance- 840 Pro 256 GB SSDI created a USB following this guide, flashed the BIOS of the motherboard with the patched version 2.70, and set the BIOS as here (except for the setting of CSM). I managed to install Maverick disabling CSM.Now I have two situations:- With the CSM disabled can load OS X without any problems, but I don't see the Win7 installation. The only "problem" is that I detect two monitors (although I have VGA and DVI connected to the same), and I see them side by side.- With the CSM enabled i can see the installation of Win7, but I can not load OS X, I get stuck on the classic Bluetooth, probably related to the video card. If I force -x I reach the desktop, but i see 3 desktops overlapped and only on the top half of the screen. I have to edit the framebuffer as explained here?I'm not allowed to attach the file config.plist, can I upload to dropbox if needed.I'm not very experienced in kext and bootloader configurations, be lenient ... If you tell me what to check to make it easier to "debug" I will be happy to do so.Thanks. EDIT: attached config.plist config.plist.zip Link to comment Share on other sites More sharing options...
Recommended Posts