novaris Posted January 19, 2012 Share Posted January 19, 2012 hi all, I've been stuck while modding the mac pro as I wanted to re use the mac pro's mounting holes to mount a motherboard tray that will hold a matx motherboard at the same time. so far I've been resorting to using crude methods to "reconcile" the difference in mounting holes (mac pro's and matx's) and I am hoping I can use a more accurate method of doing so. the plan is to use the relative positions and distance of the mounting holes to laser cut a template made from acrylic sheets then cut matx mounting holes on the same sheet. can anyone help on this matter? or does anyone have a spoilt mac pro logic board for sale somewhere? cheapest on ebay is still too expensive because they are in good working condition.t thanks Link to comment https://www.insanelymac.com/forum/topic/274841-where-can-i-find-the-mounting-dimensions-of-mac-pro-motherboards/ Share on other sites More sharing options...
novaris Posted January 20, 2012 Author Share Posted January 20, 2012 anyone....????? Link to comment https://www.insanelymac.com/forum/topic/274841-where-can-i-find-the-mounting-dimensions-of-mac-pro-motherboards/#findComment-1787795 Share on other sites More sharing options...
Jerime Pope Posted February 20, 2012 Share Posted February 20, 2012 Do you not have a Mac Pro case to get the standoff locations from? Link to comment https://www.insanelymac.com/forum/topic/274841-where-can-i-find-the-mounting-dimensions-of-mac-pro-motherboards/#findComment-1798709 Share on other sites More sharing options...
Recommended Posts