himynamesnoah Posted August 14, 2011 Share Posted August 14, 2011 So I finally got Snow Leopard installed on my computer with the following specs: AMD Phenom II x4 955 ASUS M5A88-V EVO AM3+ PNY GTX470 (Flashed 465) G.SKILL 4GB DDR3 1600 200GB HDD SATA I used nawcoms to boot and install with no flags at all, installed fine with the preset custom options on the latest 3.1. It installed Chameleon and everything, so I updated to 10.6.8 and used the legacy kernel. It works and boots fine! Now, I need help with that to do next. I cannot get my internet, I have the integrated RTL8111E, but before I though it was the 8139. So after installing the wrong kext for hours, I found the right 81XXX Lnx2Mac and will try installing it after this post. I can't get my native resolution either, which is 1280x1024 and it's stuck at 1024x720. My 470 is recognized and everything in the system profiler but shows the lower res. I don't think QE/CI is enabled either. I think I need to patch the DSDT, but I don't know what that is or how to do it. I know it tells the hardware what to do, and I think my problem is because of the lack of DSDT patching. So whenever I plug something into my computer like a flashdrive while it's booted into Snow Leo, I get a kernel panic. But it seems to work fine if the USB device is in before booting, which is why my KB and mouse work, and flash drive when they're been in the whole time. So any help is appreciated, I will go try getting internet working on it now! Thanks! Link to comment https://www.insanelymac.com/forum/topic/265565-need-help-with-what-to-do-after-installation-and-update-to-1068/ Share on other sites More sharing options...
himynamesnoah Posted August 14, 2011 Author Share Posted August 14, 2011 The 81XXX driver didn't work, any help? Link to comment https://www.insanelymac.com/forum/topic/265565-need-help-with-what-to-do-after-installation-and-update-to-1068/#findComment-1734838 Share on other sites More sharing options...
Recommended Posts