Snow 10.6.2 booting problem

[gogisha g]

Hi guys!

 

I am having an issue booting just installed Snow leopard 10.6.2 on my Hackintosh.

 

Here is my configuration

Gigabyte P35 DS3L

Q6000

nVidia 9800 GT

4 GB ram

 

Here is my installation process

1. I downloaded and burned [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] (nVidia) iso

2. I set my Bios (F7) settings (AHCI mode enabled)

3. Tried to boot [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] from the DVD drive - no success

4. I DISABLED AHCI and than I was able to boot [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] from the DVD

5. I installed than SnowLeopard 10.6.2 retail

6. Installation finished successfully with the error that the system cannot be restarted since there is not boot room installed (which is okay)

7. I switched DVDs - put back [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] in the drive - couldn't load DVD anymore (whether AHCI was enabled/disabled)

8. So I booted my 10.5.8 from another HDD and put latest boot and EFI to another drive where i installed my Snow Leopard

9. I detached all devices again and just left HDD with the Snow Leopard

10. Boot screens appears

11. I choose ShowLeopard to boot

12. ERROR

 

I have attached my BIOS settings and error message I get

 

Any ideas?

Thank you!

[gogisha g]

Anyone?

[avinash_4_ever]

in my opnion ahci must be enabled for os x , is your dvd drive ide or sata if its sata then enable achi for both dvd drive and hdd , you can use myhack installer with retail os x to install , work s fine on my system.

 

 

Having such a great hardware why install ideneb install iatkos s3 and run snow leopard like you own it man !