Some problem with Dual Boot

[chandan]

Hi installed SL using the [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] + Multibest method on a single hard drive and it worked like a charm... Updated to 10.6.4 and the CPU was recognized correctly, all was fine...

 

Then i decided to have a dual boot (need to use 3ds Max), so i erased the drive, repartitioned it using GUID scheme into two partitions.. installed Win 7 on one partition and then installed SL on the other.. This time, after upgrading to 10.6.4, the CPU would not be recognized nor would the system start without the [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] CD (i used the same settings and kexts as used in the previous successful install)...

 

Re-installed several times, with no luck..

 

So i erased the entire drive again and merged the partitions.. installed SL and all was good again..

 

So as of now i have a single partition with only Mac OS X 10.6.4 installed... But i would really like to be able to have windows on this machine too and be able to boot without the [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] CD... any help anyone...?

 

PS: ideally, i would like to have both the OS on a single disk with two partitions

 

thanks and regards,

Chandan