Jump to content
3 posts in this topic

Recommended Posts

Here are my specs:

> Mainboard : Gigabyte G31M-S2L

> Chipset : Intel G31/G33/G35

> Processor : Intel Core 2 Duo E6750 @ 2666 MHz

> Physical Memory : 1024 MB (2 x 512 DDR2-SDRAM )

> Video Card : NVIDIA GeForce 8800 GTS (Microsoft Corporation - WDDM v1.1)

> Hard Disk : ST3500641NS (500 GB)

> DVD-Rom Drive : ATAPI BD O DH4O1S ATA Device

> Monitor Type : Dell Computer DELL 2005FPW - 20 inches

> Network Card : RTL8168/8111 PCIe Gigabit Ethernet Adapter

> Operating System : Windows 7 Professional Professional 6.01.7600 (x64)

> DirectX : Version 10.00

Here is what I did. Windows 7 was pre-installed. I Installed and ran EasyBCD and created a new entry for OSX. I then created a partition and formated it NTFS. Then rebooted PC and booted from iDeneb. Used Disk Utility to erase partition and make MAC Journelised or whatever that word is. Chose my Video Driver, Nvidia 320MB. Then proceeded with the install. The install gets to about half, then reboots the PC. But here is the kicker. The PC hangs at "Verifying DMI Pool Data" Doesn't get past it. Any help would be great!

This may not be the answer you are looking for but I found that that distro is really easy to boot if OSX and Windows were installed on different HDD.

 

I am thinking your install didn't finish since it only went to half. I would try again and install and see what happens.

×
×
  • Create New...