kandela Posted July 8, 2009 Share Posted July 8, 2009 Hi, I am an almost complete beginner with osx and cant find an answer to my problem despite much googling. I am managing to install Iatkos v7 and just messing about to get it right, thats not my problem. When I have installed osx onto my hard drive and then want to reboot the dvd to add drivers etc the boot loader , darwin will not recognise the f8 key press and just goes straight into the dvd boot. the problem with this is that I have an intel i7 processor and need to write the busratio=20 at darwins cursor or the dvd crashes. The only way I have found to get my proper boot behaviour from darwin is to delete the entire osx partition and start again. could you please advise Link to comment https://www.insanelymac.com/forum/topic/174137-odd-darwin-behavior-after-install/ Share on other sites More sharing options...
Recommended Posts