AMD Kalyway 10.5.2 runs fine but starts with rd=disk0s1 only

[pantadeosz321]

Hi there!

 

I have succesfully (almost) installed Kalyway 10.5.2 AMD. If it starts - it works ok. But there is a litte problem with starting it.

 

The thing is, that when i remove the installation DVD than system doesnt boot, it shows up something like this

 

Here is my spec:

AMD Sempron 2800+ 754

Gigabyte K8NS F17 S754

HDD: Western Digital Cavair WD800JB-00JJC0

Ati Rage 128 (do you think Radeon 9550 would do much better?)

Integrated Audio AC97

 

And here is the problem:

 

------------------------

BSD process name corresponding to current thread: kernel_task

 

Mac OS version:

Not yet set

 

Kernel version:

Darwin Kernel Version 9.2.9: Sun Mar 2 00:11:08 SCI 2008; mad by ToH:xnu-1228/BUIL

-----------------------

 

If I put it (the dvd) in and boot it, than while loading components the screen goes of and it gets stuck. But, if I put the DVD, press F8 and type "rd=disk0s1" then it works just fine. I've got Ultra-ATA Western Digital HDD, in my BIOS it is detected as IDE Chanel 0 Master, Ida Chanel 0 Slave is none.

 

Any ideas or suggestions? If it was for me i wouldn't care, but i'm preparing Mac for my parents becouse i think it will be easier for them to use it.