icefireicefire Posted December 23, 2008 Share Posted December 23, 2008 I easily (and succesfully) upgraded to 10.5.6 off of iDeneb 10.5.5 (with no backup ). Now, I have only one issue: CD drive is not recognized. It was when I had Kalyway, is there a kext I can copy from my kalyway backup? Thanks for your help! Link to comment https://www.insanelymac.com/forum/topic/142563-1055-ideneb-1056-problems/ Share on other sites More sharing options...
icefireicefire Posted December 23, 2008 Author Share Posted December 23, 2008 Bump? Link to comment https://www.insanelymac.com/forum/topic/142563-1055-ideneb-1056-problems/#findComment-1011931 Share on other sites More sharing options...
Beerkex'd Posted December 24, 2008 Share Posted December 24, 2008 Bump away. Nobody can help you with this if you don't post any specs. Is the drive PATA or SATA What is the make and model of the drive controller(s) on your motherboard Link to comment https://www.insanelymac.com/forum/topic/142563-1055-ideneb-1056-problems/#findComment-1012137 Share on other sites More sharing options...
gardengate Posted December 31, 2008 Share Posted December 31, 2008 Try using an older IOATAFamily.kext? Link to comment https://www.insanelymac.com/forum/topic/142563-1055-ideneb-1056-problems/#findComment-1020657 Share on other sites More sharing options...
schnogg Posted December 31, 2008 Share Posted December 31, 2008 I just installed ideneb 1.3 (10.5.5) about 10 times over the past 24 hours to get a repeatable install proceedure and I found that on my hp dv5000 laptop, i needed support for the ich7 chipset, which was inclued in the ICHx support mpkg install on the ideneb disc. You can set that up by opening the iso disc (if you have it) with pacifist and then installing the ich support patch. I hope that works. Link to comment https://www.insanelymac.com/forum/topic/142563-1055-ideneb-1056-problems/#findComment-1020690 Share on other sites More sharing options...
Recommended Posts