sidhu Posted July 17, 2008 Share Posted July 17, 2008 Hello! I've been at this install for a day now, and rading and reformating, and reinstalling,, and... well. I have a working Kalyway10.5.2! MY computer specs are : AMD X2 4400 MSI K9N Neo mobo 2 Gig kingston Ram Nvidia 7300GT Netgear Gigabit PCI card For this build, after many tries i got myself an IDE HDD, and dedicated it to an HFS partition. The standard computer config was 3 SATA HDD's and one IDE master DVD drve. During the install I disconnected all SATA drives (mostly to prevent any goofups nd data corruption), jumped the DVD drive to a slave and attached an IDE master HDD. Note that i will need to have the SATA drives (XP install) running also. Issues : 1) I cannot get the DVI and the VGA outs of the 7300GT to work simultaneously. I have been reading a long time over this, since i would suppose the 7300 GT to be a fairly standard card, but to no avail. I can only get the DVI out working(i have to use a DVI->VGA adaptor cause of my TFT), if the VGA out is so much as connected, OSX will not boot into the GUI. 2) My USB ports are behaving funny. On one of the rear ports, I have a hub attached, and all things attched to the hub (audio dongles, external midi controller) are being detected. However, when i try to connect a FAT32 flash drive, 4gb, it is not read. Could it be that these ports are not being read as USB2 ? 3) I am now going to read on how to get a dual boot going. Thanks a super ton to everyone! I should prolly get these issues sorted myself, but after so much reading, i can only think in mush as of now! Cheers! Sidhu Link to comment https://www.insanelymac.com/forum/topic/116291-first-intall-1052/ Share on other sites More sharing options...
Recommended Posts