bolero Posted May 4, 2008 Share Posted May 4, 2008 Hey guys, i managed to install Mac os X with out a hitch, the install went pretty much without a breeze. My board is nForce 750i chipset Using leo4allV3, i choose the following customization options, as well as i left the default kernel selected chipset -> older nForce Lan-> forceDeth-V video-> Nvidia kexts audio ->ACL883 When i boot into OSX, I see taht it manages to find the Sata drive and gets the boot device (disk1s2), harddrive light flashes, but then it stops at IOATAController device blocking bus. I'm not sure what could cause this. It must be able to see my sata drive fine if it loaded fine, the installer found it, and it could find the boot device. Anyone have any ideas as to what can cause this problem? Perhaps a reinstall and choosing another kernel choice? Thanks! Link to comment https://www.insanelymac.com/forum/topic/103134-unable-to-boot-ioatacontroller-error/ Share on other sites More sharing options...
Jack Zhou Posted May 4, 2008 Share Posted May 4, 2008 If you're desparate, get an IDE drive. nForce is a nightmare if wanna get it to work with OS X. Link to comment https://www.insanelymac.com/forum/topic/103134-unable-to-boot-ioatacontroller-error/#findComment-734853 Share on other sites More sharing options...
Recommended Posts