onidavin Posted May 2, 2008 Share Posted May 2, 2008 Noob question here. After some time searching, couldn't find an answer. I just installed via Kalyway 10.5.2, and it boots up fine. However, even after creating a user, it doesn't seem to register the user creation properly. Once it boots up and I finish all the welcome screen stuff, I try to log in and it gives the 'failure' shake after a few seconds. I'm not sure how to check if the account actually exists by booting into single user mode, so I haven't been able to figure out exactly what the problem is. Any ideas on how to proceed? Link to comment https://www.insanelymac.com/forum/topic/102911-account-creation-failure/ Share on other sites More sharing options...
Recommended Posts