Jump to content

can´t apply speedstepper correctly via terminal (ver 10.7.3)


Liktwo
 Share

5 posts in this topic

Recommended Posts

first of all: the quiz won´t keep me from asking my stupid question haha!

 

i read the whole speedstepper thread, found the 10.7.3 (beta)release and tried to apply it as descriped in the thread.

i tried it for 1 whole day, always with the same error: "./speedstepper: No such file or directory"

then i spend another day with google to figure it out...with no luck.

 

 

i bet it´s just a terribly stupid mistake that i am making in the terminal. ( i am kinda new to this)

here is a pic of the exact commands in my terminal, on the desktop you see the extracted speedstepper_10.7.3_file:

lpWPp.png

 

i hope one of you guys can point me into the right direction. :help:

 

 

cheers! (and sorry for my bad english, i am not a native speaker)

 

edit: my hardware is a p8z68 pro gen3, adata s510 ssd, 8 gb ram, hd4850 gfx, lion 10.7.3 install via [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url], [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url]

Edited by Liktwo
Link to comment
Share on other sites

thx for your fast response. turned out that i only had to rename the speed_stepper_lion10.7.3_something-file file to "speedstepper"

(after patching i deletet the nullcpupowermanagement.kext, rebuilt cache and reboot -> kernel panic -> reboot again with graphicsenaber=no ->reboot again with graphicsenabler=yes -> fine :) )

Link to comment
Share on other sites

 Share

×
×
  • Create New...