Jump to content

Problems with on-board ethernet nForce adaptor

Zbiggy

By Zbiggy,
in New Users Lounge

 Share
1 post in this topic

Recommended Posts

Zbiggy
Zbiggy
Posted
Posted

While trying to explore Snow Leopard 10.6.2 ("Hazard") on GA-M56S-S3 mobo, I noticed following "misfeatures" of SL:

 

  • The on-board network interface has very low throughput: around 400 KB/s, compared to more than 10x more, when running Linux on the same hardware.
  • The adaptor isn't activated by automatic at boot-up time. I've got to open "network settings", and only then it's detected always as new eth interface (eth2, eth3 and so on), although there are still present the settings from last time, when I switched to OSX.

Any cure available for the above? Thanks in advance for any "tips & tricks".

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...