calamaro Posted September 2, 2010 Share Posted September 2, 2010 Hi to all, i'm new of this forum, i'm writing because i've a problem with iAtkos s3 v2 distro installation, the boot is ok and the initial setup too, but when appear the hard disk selection window, the software doesn't show any hard disk. Could you help me? Why doesn't show my sata hd? My config: MB: MSI MS-7387 Processor: Intel core 2 Duo 2.0 ghz HD: 500 GB sata Seagate Thanks to all Quote Link to comment Share on other sites More sharing options...
Anonomys1991 Posted September 3, 2010 Share Posted September 3, 2010 in the bios find device configuration or perihperal settings look for SATA NATIVE MODE or SATA MODE if you have SATA NATIVE MODE then make sure it is enabled this sets it into AHCI MODE if you have SATA mode make sure it is in AHCI MODE Quote Link to comment Share on other sites More sharing options...
calamaro Posted September 17, 2010 Author Share Posted September 17, 2010 in the bios find device configuration or perihperal settings look for SATA NATIVE MODE or SATA MODE if you have SATA NATIVE MODE then make sure it is enabled this sets it into AHCI MODE if you have SATA mode make sure it is in AHCI MODE I haven't SATA NATIVE MODE or SATA MODE options in my bios. I can't find AHCI option. What can i do? Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.