Jump to content
2 posts in this topic

Recommended Posts

Hi to all.

I'm using parallels desktops (amazing tool) to load Vista from my Leopard.

I have also installed before that the NTFS-3G and MACFuse packages and I had no problems before.

After I installed parallels desktops, whenever i start my windows vista from this tool , it works fine but it unmounts my "Untitiled" volume where NTFS-3G had mounted my Vista hard disk (sounds normal I should say, since it remounts it for the session as © My Windows disk or something)

The problem is that when the parallels tools are closed by properly shutting down Vista, the disk is gone. After reboot , it's remounted ok but it gets a different volume name e.g. Untitiled 2 or Untitiled 3 and so on...I'm so far at Untitiled 4 so I'm asking some help for the matter.

 

Thank you all in advance.

  • 2 weeks later...
Hi to all.

I'm using parallels desktops (amazing tool) to load Vista from my Leopard.

I have also installed before that the NTFS-3G and MACFuse packages and I had no problems before.

After I installed parallels desktops, whenever i start my windows vista from this tool , it works fine but it unmounts my "Untitiled" volume where NTFS-3G had mounted my Vista hard disk (sounds normal I should say, since it remounts it for the session as © My Windows disk or something)

The problem is that when the parallels tools are closed by properly shutting down Vista, the disk is gone. After reboot , it's remounted ok but it gets a different volume name e.g. Untitiled 2 or Untitiled 3 and so on...I'm so far at Untitiled 4 so I'm asking some help for the matter.

 

Thank you all in advance.

 

Well it was really simple....I just had to give a name to the volume label under Vista, and everything works fine now.I thought it might be useful for someone to know.

 

Regards,

 

Limneos

×
×
  • Create New...