Jump to content
Atomic_Sheep

Installation Reboot

2 posts in this topic

Recommended Posts

Hi,

 

I'm installing High Sierra on my hackintosh. The comp is old, i7 930, Gigabyte X58A-UD3R and GTX260 with old school BIOS. I'm trying to install onto a RAID 1 Mirror x2HDD setup.

 

I have successfully booted clover and then went to boot from bootable USB on which I have the HS installer and clover EFI.

 

I have -v enabled but it goes too quick to be of any use, not sure how to pause it if it all possible. Basically, it starts running through lines of stuff and then it resets all of a sudden.

 

After the reset, the USB is no longer recognised by the computer and I have to pull it out and put it back in, but I think this last point is largely irrelevant.

 

Is there some way for me to pause the -v to see where the error occurs?

Share this post


Link to post
Share on other sites
Advertisement

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

×