Jump to content
Dallastyle

Install Clover on Raid based Hackintosh

1 post in this topic

Recommended Posts

Hello Insanelymac,

I've successfully installed Mac OS X Sierra on 2 32gb flash drives with them as a JBOD Raid. I can only get into the hackintosh if I use another USB flash drive with Clover installed on it. I've tried using a clover installer however that just installs on my Raid Disk. I've also noticed that when I open clover configurator, there are 2 EFI partitions but both of them were empty. I've tried moving the contents of the EFI on my Raid disk that clover installed but my BIOS does not detect it. Also when I use the other flash drive to boot into clover, there is another volume called "BOOT OS X" right next to my Raid Disk Volume that I use to boot from. I just want to install and boot off of my Raid usb flash drives. Really running out of options, Thanks guys.

Share this post


Link to post
Share on other sites
Advertisement

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

Announcements

  • Similar Content

    • By jrbros1
      Hi there,
       
      So I have my Windows computer, used a USB with Clover setup to boot into Mojave OS that I installed on the SD card in the computer. The world was a great place and all was well!

      Then I did the steps to partition the pc system to now include the additional drive that I would put Clover on. Here's where I messed up: Instead of directly copying over the full Clover folder into the EFI folder of the new drive (which just had the Boot & Microsoft folders in it), I replaced the EFI's boot folder with Clover's boot folder. So the EFI folder now contains a Microsoft folder, a Clover folder, and Clover's Boot folder only.

      Now, I only can access the Clover boot up menu, the macOS, but no Windows at all. Even if I go into BIOS and pick Windows Boot Manager or Partition 1 for the start up, I get a black screen for both. I can still access the macOS as well as Shell, but I don't know what that does other than displaying all of the yellow text fly by..

      Is there a kind soul out there that can help me get Windows back to boot? Keep in mind I'm a bit of a newbie here so laying out the common-sense steps would be helpful!

      Thank you in advance!
×