So I have my Windows computer, used a USB with Clover setup to boot into Mojave OS that I installed on the SD card in the computer. The world was a great place and all was well!
Then I did the steps to partition the pc system to now include the additional drive that I would put Clover on. Here's where I messed up: Instead of directly copying over the full Clover folder into the EFI folder of the new drive (which just had the Boot & Microsoft folders in it), I replaced the EFI's boot folder with Clover's boot folder. So the EFI folder now contains a Microsoft folder, a Clover folder, and Clover's Boot folder only.
Now, I only can access the Clover boot up menu, the macOS, but no Windows at all. Even if I go into BIOS and pick Windows Boot Manager or Partition 1 for the start up, I get a black screen for both. I can still access the macOS as well as Shell, but I don't know what that does other than displaying all of the yellow text fly by..
Is there a kind soul out there that can help me get Windows back to boot? Keep in mind I'm a bit of a newbie here so laying out the common-sense steps would be helpful!
I'm getting an error when i try to install Catalina 10.5.6 Install on HP 800 G1 SFF Haswell.
This happens on the first reboot after installing MacOS (see atached image).
I'm using Opencore 0.6.0.
config.plist checked with opencore.slowgeek.com
HP 800 G1 SFF
i7 4785t Haswell
Intel hd4600 (using just iGPU)
I attached EFI, log error opencore, error capture.