WubaDee Posted November 16, 2014 Share Posted November 16, 2014 I have recently completed an installation of Yosemite with the Clover boot loader. I have Windows 8 installed on an SSD that I can boot into by selecting it from the startup options. My problem is that when I boot into Clover, I can see the drive, and Clover says "Boot Windows from Legacy HD" but when I select it a Windows logo appears, and freezes immediately. I was under the impression that Windows 8 does not use legacy by default but instead uses UEFI. I was hoping I could get some help with understanding the setup I have, whether or not I have Windows 8 in legacy or UEFI mode. And then from there what I should do to be bale to boot into Windows from Clover. I have looked around this forum as well as done some searches but I was unable to find anyone with the same problem as me. If anyone could help or direct me to a resource that will help I would greatly appreciate it. I can post my setup if it is needed to determine a solution. Link to comment Share on other sites More sharing options...
Recommended Posts