Installation on GA-H87M-D3H and i5 4570

[JoSbg]

Hello

 

I was reading a lot during last few weeks about hackintosh.

As my macbook "CoreDuo 2GHz" is not really up-to-date any more i was thinking about a replacement and that's why i was reading about hackintosh.

As i wanted to have the latest hardware i was waiting for 10.9 and then i orderd the following hardware:

- GA-H87M-D3H

- i5 4570 boxed

- 8 GB Kingston RAM (2x4GB)

- Samsung EVO 120GB SSD

 

What i have read it should be possible with my hardware to install 10.9 but i have not found a nice decription or tutorial using that equipment.

Does anybody know a good link or can tell me how i should do it so that everything works fine quiet fast?

 

Thank you.

Jo

 

[rayap]

Jo,

I have same board and processor and mavericks is working well. Everything you need to know is within this forum.not sure about any particular guide. If you cannot connect the ssd to your MacBook, use two USBs, one for Clover and other - 8G - for the OS, created by the createinstallmedia method. This should get you going.

[JoSbg]

Can you give me a little more information on that?

Until now i have never read anything about "clover".

I was only getting information about "[url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url]/[url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url]" and "Myhack".

[slemblod]

I have similar hardware to you. Have a look at my guide here: http://www.insanelymac.com/forum/topic/291208-haswell-success-ga-z87m-d3h-gtx-670/

 

Hope I could help.