Michał Mildner Posted December 14, 2012 Share Posted December 14, 2012 Hello, I am new to this forum, so hello:) I have problem with booting installed 10.8.2 I have used tonymacx86 USB installer, everything worked ok, no problems at all. My specs: T61p, C2D T7700, 4GB of RAM, Seagate Momentus SSHD, nvidia Quadro FX570M. After installation, I created /Extra/KextStore directory, and for the beginning put there fakesmc.kext and nullcpu(...).kext, then installed chameleon 2.1, and tried to boot it from HDD. I'm booting with -v npci=0x2000(problem with PCI Conf begin) and I've tried a couple of other parameters, but with no effect. I also tried to put fakesmc and nullcpu into /S/L/E - didn't worked. Everything is ok, FakeSMC messages at the beggining - seems ok, until this moment: Waiting for DSMOS... (few seconds of break) Previous Shutdown Cause: 3 (something about bluetooth - anyway, completed) NVDANV50HAL loaded and registered. ACPI_SMC_PlatformPlugin::start - waitForService(resourceMatching(AppleIntelCPUPowerManagement) timed out and now Kernel Panic (I can put a photo here if it's necessary) When booting from USB it looks the same, but after ACPI_SMC(...) timed out is DSMOS has Arrived and system loads normally. Any ideas? I tried to find solution, but no effect:( Please Help Regards, Michal Link to comment Share on other sites More sharing options...
Recommended Posts