Jump to content

I can't install ML Please help me!


iPho
 Share

2 posts in this topic

Recommended Posts

Hello everyone, I have done the ML GM USB, but I have some problems with booting.

If I don't write any command when I boot the apple logo appears for about 10 seconds and then the fans start but I see nothing in the monitor (it goes on standby mode as when I turn off the PC)

Booting with -v instead of the apple I see the code but then the monitor goes into standby

Starting with -x it does the same problem as starting without commands

Starting with GraphicsEnabler = yes the installation wizard start but when I am in the selection panel, I see only the USB drive, I do not see the disk of the PC.

Strange because if I boot with iATKOS l2 CD it finds the drives correctly

Please help me, I need ML :)

 

Sorry for my bad english

 

My hardware is a preassembles Dell xps 8000 with i7 860 nvidia gts 240gpu 4gb of RAM 1333mhz

The guide that I followed is this http://thetecherra.com/2012/02/17/tutorial-run-os-x-mountain-lion-10-8-on-a-pc-hackintoshosx86-from-start-to-finish-2/

Link to comment
Share on other sites

Hello everyone, I have done the ML GM USB, but I have some problems with booting.

If I don't write any command when I boot the apple logo appears for about 10 seconds and then the fans start but I see nothing in the monitor (it goes on standby mode as when I turn off the PC)

Booting with -v instead of the apple I see the code but then the monitor goes into standby

Starting with -x it does the same problem as starting without commands

Starting with GraphicsEnabler = yes the installation wizard start but when I am in the selection panel, I see only the USB drive, I do not see the disk of the PC.

Strange because if I boot with iATKOS l2 CD it finds the drives correctly

Please help me, I need ML :)

 

Sorry for my bad english

 

My hardware is a preassembles Dell xps 8000 with i7 860 nvidia gts 240gpu 4gb of RAM 1333mhz

The guide that I followed is this http://thetecherra.c...rt-to-finish-2/

 

look this:http://lnx2mac.blogs...figuration.html

Link to comment
Share on other sites

 Share

×
×
  • Create New...