PookyMacMan Posted February 13, 2012 Share Posted February 13, 2012 Hello. I just got all of my audio outputs showing up in System Preferences using Nodes To Patch in VoodooHDA! However, now my issue is being able to use all of them. I'm not as much concerned about getting 5.1 or 7.1 channel since I'm not running a HTPC (although that would be nice), but I would at least be able to get all outputs working at the same time (i.e. have four sets of speakers connected at once). I tried creating an aggregate device in Audio/Midi Setup, but each time I did it, it would only come out of one output, I could not control the volume, and there was a lot of crackling, delay, etc. So, my questions are: 1. Am I doing something wrong in the creation of an aggregate device in Audio/Midi Setup? Is there something I can do to fix the problems above? 2. Is there a way to configure the settings so that the four line-out jacks are seen as one output? Thank you very much! Link to comment Share on other sites More sharing options...
Recommended Posts