Jump to content

problem with installation 10.4.6


3 posts in this topic

Recommended Posts

hello, I've a problem with the installation, all goes good but with mode -v arrives to one part that says:

SAM Multimedia: READ or WRITE failed, ASC=0x11 ASCQ= 0x00

followed of disk1s3 I/O error.

 

I've a DVD LG as PRIMARY SLAVE and a hard disk as PRIMARY MASTER. I'm using a 80 pin IDE cable.

 

please help.

Link to comment
Share on other sites

The SAM error means there is a problem reading the DVD.

 

Try burning the DVD again on the slowest speed. If you have a different brand or type of media (-r, +r, rw), then try that.

 

Maybe update the firmware on your DVD drive.

 

Try to borrow another DVD drive.

 

Put the hard drive in another computer, install and then replace the hard drive into the original computer.

Link to comment
Share on other sites

 Share

×
×
  • Create New...