iaktos s3 v2 bootloader error

[pjc]

Hi guys,

I'm a complete noobie at osx86 and the whole hackintosh idea, I've recently installed iaktos s3 v2 and then used userDSDT in [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] to install the correct kexts for my mobo. unfortunately after restarting the system I kept recieving kernal panic message "The computer must be restarted, press the power ...." but if i select the partion using [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] disc then it runs.

I'm very confused I dont know what to do, this is my third installation and I'm hoping I wont need to do it again.

 

System:

Gigabyte GA P55A-UD3 (rev. 2)

Intel i5 760 2.8Ghz

Corsair 4Gb RAM

Asus 8400GS Silent 512mb

[verdant]

Hi guys,

I'm a complete noobie at osx86 and the whole hackintosh idea, I've recently installed iaktos s3 v2 and then used userDSDT in [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] to install the correct kexts for my mobo. unfortunately after restarting the system I kept recieving kernal panic message "The computer must be restarted, press the power ...." but if i select the partion using [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] disc then it runs.

I'm very confused I dont know what to do, this is my third installation and I'm hoping I wont need to do it again.

 

System:

Gigabyte GA P55A-UD3 (rev. 2)

Intel i5 760 2.8Ghz

Corsair 4Gb RAM

Asus 8400GS Silent 512mb

 

Try booting with -v busratio=21