Jump to content
5 posts in this topic

Recommended Posts

Hi,

Earlier I installed Hazard 10.6.2 Snow Leopard Server on my AMD PC that was compatible for it. It installed fine and my computer restarted. However, I went to BIOS to change the boot priority to my hard drive and that worked, but for some reason my only SATA device detected is my disc drive? So when I boot up my computer I am taken to a black blinking cursor screen. What went wrong?

I replaced my SATA cables of my hard drive and now the BIOS is actually detecting the disk. But I try to boot up it now says hard drive not detected and goes to a blinking cursor...

http://i30.tinypic.com/209lzig.jpg here's the message.

What mode is you sata set to in your bois?
Mode?

Here are the settings.

http://i26.tinypic.com/aue1yv.jpg

http://i28.tinypic.com/52csid.jpg

 

SATA ports 1-6 are set to IDE...i really don't understand why it won't detect.

×
×
  • Create New...