Can't boot after installation of battery meter fix

[matusa]

Hi all!

 

I have installed iPC 1.5.6, with almost everything working in my To{censored}ba R200.

Tried to fix the battery meter and then I couldn't boot again.

 

I'm stuck at Mac Framework....

 

I have backed up the AppleACPIPlatform.kext and the PowerManagement.bundle before installing the pkg, and tried copying them back booting with the DVD in single user, but I still can't boot.

 

Any ideas of how to fix this? How can I get the battery meter working again?

 

Thanks!

[petopay]

Just make sure you have installed ACPIBattery.kext, If you don't just reply. I don't know how to bring it on here because Upload Attachment keeps very long.

[matusa]

I reinstalled leopard.

 

Now I have working almost everything.

About the battery meter, in the System Profiler it shows me this>

Battery Information:

 Model Information:
 Serial Number:	Unknown-G71C00056210-Li-ION  -0000000467
 Device name:	G71C00056210
 Pack Lot Code:	0000
 PCB Lot Code:	0000
 Firmware Version:	0000
 Hardware Revision:	0000
 Cell Revision:	0000
 Charge Information:
 Charge remaining (mAh):	2441
 Fully charged:	Yes
 Charging:	No
 Full charge capacity (mAh):	2441
 Health Information:
 Cycle count:	237
 Battery Installed:	Yes
 Amperage (mA):	0
 Voltage (mV):	11400

System Power Settings:

 AC Power:
 System Sleep Timer (Minutes):	10
 Disk Sleep Timer (Minutes):	10
 Display Sleep Timer (Minutes):	10
 Display Sleep Uses Dim:	Yes

Hardware Configuration:

 UPS Installed:	No

AC Charger Information:

 Connected:	Yes
 Charging:	No

 

Because of that, I think I just have some problems with the icon of the taskbar.

 

Any ideas how to get that working?

 

Also, the internal bluetooth isn't working.

[petopay]

Make sure u have ACPIBattery.kext installed in root directory S/L/E.

[matusa]

I don't have the ACPIBattery.kext ... I'll search it arround the forums I think and put it in /S/L/E

Thanks!! hope that works...

 

EDIT> Used VoodooBattery and worked like a charm. Thanks!