famousginni Posted November 7, 2009 Share Posted November 7, 2009 Well, after very few responses from the community... downloading and trying EVERY different iso from different releasers (iAtkos, iDeneb, iPC, Kalyway....)available. I've finally managed to install Kalyway 10.5.2 The install went perfectly. Just incase I save the install logs to a usb drive while it was installing. Keep in mind that this install log was saved a while before the install was completed so it isn't complete. Once the install was complete, it told me it was going to reboot. The black screen with a cursor appeared and it never restarted. I manually restarted the computer by pressing the reset button. Booted into Darwin, and it selected the OSX. The loading screen came up like the one shown here. And then i got a error which told me to restart the computer. Like the one shown below. I've tried booting with -v and also -x. But it didn't work. Any Help Please.. I know it should work because the install went fine.. maybe its the kexts or something. I also think I might have chosen the wrong video drivers, I have a NVidea 7050 with Shared Memory and I'm sharing 128MB so I chose NVInject-128. Is that the right one? Other than that .. any help would be appreciated. Please.. Link to comment https://www.insanelymac.com/forum/topic/196305-kalyway-1052-first-boot-after-install-problems-help/ Share on other sites More sharing options...
vilpostus Posted November 7, 2009 Share Posted November 7, 2009 Use -v boot flag. Yes, it will not make the install work, but that will let you see where it "hangs". It will most likely be "still waiting for root device" error. http://www.insanelymac.com/forum/index.php?showtopic=87901 Link to comment https://www.insanelymac.com/forum/topic/196305-kalyway-1052-first-boot-after-install-problems-help/#findComment-1322450 Share on other sites More sharing options...
famousginni Posted November 8, 2009 Author Share Posted November 8, 2009 Well, I used the -v flag and it didn't work. I figured out that the video driver was incorrect and I re-installed it, this time I didn't choose any video driver and guess what? It worked, the install booted and showed me the welcome video although it was a little laggy, but everything else was fine. Now if I need any drivers for this please let me know and let me know what kext and how to install them, because this is the first time I've gotten this far. Um, my sound and networking also don't work so I probablly need kexts for that also. Video: NVidea 7050/ NForce 610i (Shared: 256 MB) Audio: VIA VT1708B Networking: Realtek RTL8201CP Link to comment https://www.insanelymac.com/forum/topic/196305-kalyway-1052-first-boot-after-install-problems-help/#findComment-1323212 Share on other sites More sharing options...
Recommended Posts