Jacd Posted October 20, 2009 Share Posted October 20, 2009 Dalton, Followed your guide for install. and everything went fine untill I restart. It will not boot. It runs into a loop and brings me back to the MSI screen over and over. any sugestions. Link to comment https://www.insanelymac.com/forum/topic/193064-running-in-a-loop-after-install/ Share on other sites More sharing options...
mg100796 Posted October 20, 2009 Share Posted October 20, 2009 Dalton, Followed your guide for install. and everything went fine untill I restart. It will not boot. It runs into a loop and brings me back to the MSI screen over and over. any sugestions. When you boot up type the "boot flags" -v -x, and post where it get hung up at. Just for safe measures, post the last few lines, because a lot times when mine froze it would screw up way before, but when it tries to load it is when it freezes. You also might want to try those flags with -x32. Sometimes the kernal tries to load 32 bit kexts in 64 bit mode (Not a good idea). Link to comment https://www.insanelymac.com/forum/topic/193064-running-in-a-loop-after-install/#findComment-1304568 Share on other sites More sharing options...
Recommended Posts