Jump to content

Nvidia 9800 GTX+ 1Gb


altares
 Share

5 posts in this topic

Recommended Posts

Hi everyone, I believe that these videocards : 9800GTX+ (1GB, 55nm version) have not been discussed enough on these forums about their support on Leo.

So please tell us your story if you managed to have one working on your setup/or not...

You should tell us the distribution you used(XxX 1.5.6, iAktos..) , the kext, and the name of the card..etc.(motherboard..) :rolleyes:

Thank you very much ! :D

 

Update:

A member sent me a PM, and it worked for him:

9800GTX+1GB, iATKOS 5i 10.5.5 ,EFI String for OSX86Tools

The 10.5.6 update worked too.

Thank you C. D. for your response !

Link to comment
Share on other sites

  • 1 month later...
Hi,

MTC 9800GTX+ 1gig

Works on XxX 10.5.6 PPF1 with nvinject 9800

Motherboard: Gigabyte GA-P35-DS3

 

 

I have a Gigabyte 9800gtx+ 1gb but i can't use it corretly.

System profiler report:

 

Chipset Model:	Graphics by NVIDIA
 Type:	Display
 Bus:	PCIe
 PCIe Lane Width:	x16
 VRAM (Total):	512 MB
 Vendor:	NVIDIA (0x10de)
 Device ID:	0x0612
 Revision ID:	0x00a2
 ROM Revision:	NVinject 0.2.1
 Displays:
BenQ T2200HDA:
 Resolution:	1920 x 1080 @ 60 Hz
 Depth:	32-bit Color
 Core Image:	Software
 Main Display:	Yes
 Mirror:	Off
 Online:	Yes
 Quartz Extreme:	Not Supported
 QuartzGL:	Supported
Display Connector:
 Status:	No display connected

 

so it use 512mb instead 1gb and Quartz Extreme support is disabled.

Any suggestion?

THANKS

Link to comment
Share on other sites

 Share

×
×
  • Create New...