Jump to content

"b0" error on reboot - cant get past this


1 post in this topic

Recommended Posts

I run a vista64 home premium machine off of my main (sata) drive and installed Kalyway_Leo_10.5.1 on my secondary (ide) drive. its 120 gig completely dedicated for osx. i got through booting and installing with a green 'sucessfully installed' screen then rebooted

BTW i chose:

-vanilla kernal

-vanilla acpi

-NOT the sse2

-ati inkject driver

-azalia out

-boot mbr


ive set my osx drive to primary boot and wait for things to load up, it takes a while to get through a couple screens that almost fooled me for frozen but eventually it snags at the "b0" error.


the wiki guide ive been using on how to get around the b0 error said to go into the installation screen to start the Terminal, i did this, followed instructions to where i should be able to choose a disk, but it wasnt listed.


any thoughts?

im off for the evening, but thanks in advance for any advice anyone has


intel quadcore processor

abit ip35 pro-xe

4g ram

saphire ati radeon

Link to comment
Share on other sites


  • Create New...