cainedna Posted May 1, 2008 Share Posted May 1, 2008 I've installed Leopard on this system before using iAtkos, but was never able to patch around the 4GB RAM issue. With Leo4All v3, it mentions the patch being a part of the installer. Using SATA HD and DVD drives, no IDE needed. At 2 minutes, the installer locks up. Does anyone have a suggestion of what to try? I've tried every BIOS config there is, but no dice. Link to comment https://www.insanelymac.com/forum/topic/102665-leo4all-v3-locks-up-near-end-of-install/ Share on other sites More sharing options...
jkspost Posted May 1, 2008 Share Posted May 1, 2008 Same here on a DS3L board. I've tried with and without AHCI enabled. Leo4allV2 installed fine from my IDE DVD drive onto SATA HD drive , but it locks up randomly once installed... The most succesfull install I have done so far, was with the Kalaway 10.5.1 + update (The 10.5.2 release gives me USB problems) Link to comment https://www.insanelymac.com/forum/topic/102665-leo4all-v3-locks-up-near-end-of-install/#findComment-731659 Share on other sites More sharing options...
Mircea Posted June 21, 2008 Share Posted June 21, 2008 same setup lockup here. i have removed 2 of the 4gb of ram, completed setup succesfully, then put the ram back in. it worked! on a side note, this problem also showed up when applying the 10.5.3 update; again, temporarily removing 2gb's worked. Link to comment https://www.insanelymac.com/forum/topic/102665-leo4all-v3-locks-up-near-end-of-install/#findComment-792038 Share on other sites More sharing options...
Recommended Posts