Search the Community: Showing results for tags 'vsphere'.
Found 3 results
oli-j posted a topic in OSx86 10.8 (Mountain Lion)I'm Attempting to install ML (retail) in to a VM on ESXi vSphere 5.1 // HP Proliant Microserver N36L (AMD) but I'm having a mouse input issue. Followed the following guide, but I used the AMD kernel from the development thread: http://www.insanelym...-for-beginners/ As per the guide I used my retail ML dmg to restore to USB, installed chameleon, extracted the packages from basesystem, AMD_kernel from the AMD dev thread, FakeSMC r615 and NullCPUPowerManagement kexts. I went with iMac 10,1 for the SMBios. To run the install I extracted the USB to a dmg and uploaded it to a datastore then connected the cd drive to the dmg. VM is set for OS X 10.7 (highest it goes to, but apparently this works). I have also unlocked ESXi to run OS X on non-apple hardware (I have previously got OS X SL 10.6 running using the legacy kernel). My issue was the installer loads to the language selection menu, but with no mouse and keyboard support so I can't get any further. I have used USB Bus fix, Graphics enabler, Force 64bit, Ethernet Built in and cpus=1. (didn't work). I then started adding in kexts from my SL install with which I got a stable 10.60 install, (I did find that any tweaks on that previous system did cause it to loose mouse/keyboard input through the console and over vnc, so it seems to be pretty fussy): AppleACPIPS2Nub.kext ApplePS2Controller.kext IOAHCIBlockStorageInjector.kext IOATAFamily.kext IONetworkingFamily.kext NullCPUPowerManagement.kext TotallyFixStillWaiting.kext fakesmc.kext I then got keyboard, but no mouse input - any ideas how to get this working? Kind of important as I need to use disk utility to format the disk before install! Lastly I then tried the following as a latch ditch effort: AHCI_Extended_Injector.kext AHCIPortInjector.kext AppleAHCIPort.kext But with no success. Any insight on what to try next?
Hi folks, I have successfully installed High Sierra in a Virtual Machine on VMWare vSphere 6 with a NVIDIA GT 1030 passed through for graphics with the web drivers installed. It's my understanding that Audio over HDMI does not work on this card so I have been looking at alternatives. I have a Fiio E10K USB DAC that is supported under OS X apparently. I tried with USB pass-through and it is detected but there is no sound. I also tried USB pass-through on Windows and it didn't work with the same issue with xHCI but it did work with EHCI + UHCI which only supports 1.1 and 2.0 devices. I don't mind sacrificing USB3 support to get audio working but I have not had success so far on OS X. Has anyone successfully gotten USB Audio working on 10.13? Cheers!