Search the Community: Showing results for tags 'clover wont boot'.
Found 1 result
First post, thank you all for any help offered. I am coming from a certain commercialized hackintosh community - after seeing such amazing vanilla installs and reading of the talent here, I decided to have a go at not using such software methods. And I immediately got myself into a predicament BACKSTORY I successfully upgraded from Mavericks to Mojave 10.14.2 but decided to start over and do a clean install because my Vega Frontier was not playing OOB even with Lilu & whatevergreen - and there was a lot of 'code junk' Clover barfed at boot from this 'commercialized software'. SUCCESS I created Mojave USB installer from scratch using the latest Clover, it worked fine, got me to the Mojave install screen. PROBLEM For reasons unknown to me, I decided for one last ditch effort to see if I could get my already installed Mojave playing nicer - instead of starting over clean. So I installed the latest Clover on my Mojave SSD, (it had a Clover version YEARS ago when I last installed Mavericks) and I replaced the EFI file with the kexts and config of my USB EFI file because I figured, since the USB installer launched, it was all good to go. Now nothing boots after BIOS. Not my Mavericks drive, Mojave SSD, nor my USB Mojave Installer. They all hang right where Clover usually launches. I look at my USB lights and nothing flashes... The only drive I can use is Windows 8.1 (my testing environment) and not from Clover. That's just booting windows up without any HD's plugged in. Is there a way to rescue my predicament? I don't have another Mac computer and CloverConfig only runs on Mac. Is there a way to fix the USB from Windows? Thanks! Specs: Gigabyte GA-X58A-UD5 rev. 2.0, FC BIOS, i7-980x, Vega64 Frontier Edition, Nvidia GTX480, 24 GB 1333 RAM, SSD + various hardrives