Search the Community: Showing results for tags 'GT730'.
Found 2 results
Hello, i'm here because i have a problem with the VGA output of my Nvidia GT730 (4 GB). I'm currently running Mavericks 10.9.5 and i have only one monitor connected to the HDMI port of the video card. Since the GT730 has VGA, HDMI and DVI i tried to connect a second monitor to the VGA port but i couldn't see the HDMI display and the VGA resolution was stuck at 1024x768. Can i do something to enable the dual monitor ? I haven't installed Nvidia Web Driver, but when only the HDMI is connected it runs at full 60 fps. Thank you all in advance ! PS: I use Clover as bootloader.
This is a first post from me but I have been following the site for many years and thank you to everyone working on this project. I have had various builds up to now and I currently have a running 10.11.4. I have audio, Ethernet etc.. working from the various kexts, but I do have one problem. I recently bought a Gigabyte GT730 2Gb, I deleted the nvdisable and replaced with nvdrv=1 and the system boots. I have a DVI monitor and a HDTV, both function on bootup but without any acceleration on either the monitor or TV. I am not a new user, but would appreciate greatly if someone could carefully point where I should be looking now, do i need to edit the edid table? If I need to do something, please instead of saying read the xxxxx post (which I have been doing non stop for days and days) could someone give me the correct instructions. The machine was much faster using the Point of View GS 8400 512mb, as I understand this is supported natively hence the acceleration. Again, thank you to everyone who has made this project possible. Gigabyte EP45 UD3LR OCZ reaper 1066 * 8gb Gigabyte GT730 2Gb WD 500Gb HD x 2 Mark Stewart