Jump to content
InsanelyMac Forum

iust79

Members
  • Content count

    5
  • Joined

  • Last visited

About iust79

  • Rank
    InsanelyMac Protégé
  1. Unable to mount NTFS on 10.6.6

    I managed to access my ntfs partitions by removing the fusefs.fs this let me to access only in read mode those partitions.
  2. Unable to mount NTFS on 10.6.6

    same problem. i installed 10.6.6i on a intel based Gigabyte mb (i848 chipset, I think), p4 630, hdd sata. i manage to boot, but after S.O. loads apear two window: one says that fusefs.fs.... wasn't install properly and wasn't load. Second window says that tuxera cannot start becase the fusefs wasn't loaded. i tryed to install latest versions of mac fuses, but still doesn't work. in the older versions (10.5.2, 10.6.2) i hadn't this problem.
  3. Marvell Yukon 8001 - the driver

    Partially solved I installed the Marvell.Gigabit.pkg http://forum.insanelymac.com/index.php?act...ost&id=9959 open Terminal sudo /usr/bin/installer -pgk 'your pakage path'/Marvell.Gigabit.pkg -target / and after a few seconds it detected my yukon 88e8001 onboard NIC and I was able to conect to internet I said partially because of that my ISP uses dhcp. I first configured my ethernet port to use dhcp , but after reboot, I wasn't able to conect the ethernet port was still there but under it wrote "no ip address" I enter manually the ip, dns, gateway and now I was able to conect I don't know if this configuration will work next time I reboot (and after my ISP change my IP I will have to change it) Does anyone know why is that happening ?
  4. Marvell Yukon 8001 - the driver

    on dmesg I received the following message: ..... skgeosx is not compatible with its superclass 20IOEthernethController superclass changed? Failed to load extension com.musashi.skge couldn't alloc.class "skgeosx" ...... I've tryed to install a tp-link nic on a pci slot still doesn't detect any ethernet port....
  5. Marvell Yukon 8001 - the driver

    I have problems with the onboard network card on my hackintosh I used kalyway 10.5.2 installation cd to install it on my extended partition. my nic is a marvel yukon 8001 on a i848 gigabyte motherboard. my mac os x doesn't recognize the NIC. If I go to System Preference -> Network it sees only two serial built in ports and none ethernet port. I tried to install the skge.kext_02g package but it still doesn't work. when I reboot it says something that it can't load that extension. I will come back with the exact message from the dmesg. any ieas what can i do? if I will install a second PCI NIC do you think that this will solve the problem and the os x will see the NIC? 10x
×