Jump to content
InsanelyMac Forum


  • Content count

  • Joined

  • Last visited

  1. DTJ

    [HOW TO] ATI HD 4350

    I attempted these instructions with 10.6.5 and a Asus EAS 512MB 4350 Silent, and was unable to get this card working. I used Chameleon RC5 v629 with graphics enabler on and the v2 injector kext (which I understand injects the device ID into the 4600 controller kext) on a clean installation. The monitor is linked over DVI. I wonder if anyone has tried using DSDT? There seems to be something sinister going on with this card - I've had it working previously in 10.6.2 with the 4500 controller and X2000 kexts, but even then the performance was shotty. I wouldn't even deal with this card if there were a supported, low profile, PCIe, fanless video card for my HTPC. Any suggestions on alternatives to this card?
  2. DTJ

    ATI Radeon HD4350 PCIe

    I can confirm that it is in fact the DSDT configuration which is preventing normal functioning. I had to use a DSDT from somebody else in order to even boot Snow Leopard because I have a picky motherboard (P45-T2RS). They had enabled their own graphics card through DSDT which I had to remove. After doing this, the card is "halfway" recognized - system profiler identifies the card as a Radeon 4300 Series but believes the card has 256 VRAM. Resolution control is still disabled, along with QE/CI. Could somebody who has the card working post their information from IORegistryExplorer? It could help a lot in building the DSDT. Thanks everyone! I feel like we're very close to getting this card working for everyone. DSH
  3. DTJ

    ATI Radeon HD4350 PCIe

    Mcgrath, thanks for your reply and detailed instructions. However, I was unable to get the card working. I'm beginning to suspect that my DSDT file is causing the problems. Otherwise, has anyone else had trouble with kernel panics originating from the ATIX2000 kext?
  4. DTJ

    ATI Radeon HD4350 PCIe

    Hi all, I've been unable to get this card working using any of the described methods. Could someone who has successfully driven the card with full QE/CI please post a completely detailed step by step set of instructions, complete with the files that they used? It would be much appreciated for all of us who still haven't figured out what we have been doing wrong. Thanks, DSH