Jump to content

magnusart

Members
  • Content Count

    4
  • Joined

  • Last visited

About magnusart

  • Rank
    InsanelyMac Protégé
  1. So is there any restriction on M.2 SSD Harddrive. I found Samsung 850 EVO series SSD 500GB M.2 at a local vendor, just to double check: this SSD would work? Edit: Also, do I need to replace the WiFi as well?
  2. Too bad! Well, at least I know it's not going to work. Spent better part of 2 days on this. Are there any further information around hynix and why it won't work are there work ongoing that will likely change in the future? Thanks for the help so far even if this might be the end of the journey for me.
  3. Thanks for the reply. Below is the relevant output from sudo lspci -vvnn. I've also looked into the PCIO Path further below. I think it should fit the current config? I guess I'll give the scripts a spin. 04:00.0 Non-Volatile memory controller [0108]: Device [1c5c:1284] (prog-if 02 [NVM Express]) Subsystem: Device [1c5c:0000] Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 0 Interrupt: pin A routed to IRQ 16 Region 0: Memory at de400000 (64-bit, non-prefetchable) [size=16K] Capabilities: [80] Power Management version 3 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1+,D2-,D3hot+,D3cold-) Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME- Capabilities: [90] MSI: Enable- Count=1/8 Maskable+ 64bit+ Address: 0000000000000000 Data: 0000 Masking: 00000000 Pending: 00000000 Capabilities: [b0] MSI-X: Enable+ Count=65 Masked- Vector table: BAR=0 offset=00002000 PBA: BAR=0 offset=00003000 Capabilities: [c0] Express (v2) Endpoint, MSI 00 DevCap: MaxPayload 512 bytes, PhantFunc 0, Latency L0s <1us, L1 unlimited ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset+ DevCtl: Report errors: Correctable+ Non-Fatal+ Fatal+ Unsupported+ RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+ FLReset- MaxPayload 256 bytes, MaxReadReq 128 bytes DevSta: CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr- TransPend- LnkCap: Port #0, Speed 8GT/s, Width x4, ASPM L1, Exit Latency L0s <1us, L1 <64us ClockPM+ Surprise- LLActRep- BwNot- ASPMOptComp+ LnkCtl: ASPM L1 Enabled; RCB 64 bytes Disabled- CommClk+ ExtSynch- ClockPM+ AutWidDis- BWInt- AutBWInt- LnkSta: Speed 8GT/s, Width x4, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt- DevCap2: Completion Timeout: Range B, TimeoutDis+, LTR+, OBFF Via message DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR+, OBFF Disabled LnkCtl2: Target Link Speed: 8GT/s, EnterCompliance- SpeedDis- Transmit Margin: Normal Operating Range, EnterModifiedCompliance- ComplianceSOS- Compliance De-emphasis: -6dB LnkSta2: Current De-emphasis Level: -6dB, EqualizationComplete+, EqualizationPhase1+ EqualizationPhase2+, EqualizationPhase3+, LinkEqualizationRequest- Capabilities: [100 v2] Advanced Error Reporting UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol- UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol- UESvrt: DLP+ SDES+ TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol- CESta: RxErr+ BadTLP- BadDLLP- Rollover- Timeout+ NonFatalErr- CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+ AERCap: First Error Pointer: 00, GenCap+ CGenEn- ChkCap+ ChkEn- Capabilities: [150 v1] Device Serial Number 6c-f9-00-90-61-2e-e4-ac Capabilities: [160 v1] Power Budgeting <?> Capabilities: [1b8 v1] Latency Tolerance Reporting Max snoop latency: 3145728ns Max no snoop latency: 3145728ns Capabilities: [300 v1] #19 Capabilities: [900 v1] L1 PM Substates L1SubCap: PCI-PM_L1.2+ PCI-PM_L1.1+ ASPM_L1.2+ ASPM_L1.1+ L1_PM_Substates+ PortCommonModeRestoreTime=120us PortTPowerOnTime=10us Kernel driver in use: nvme Kernel modules: nvme *-pci:3 beskrivning: PCI bridge produkt: Sunrise Point-H PCI Express Root Port #9 tillverkare: Intel Corporation physical id: 1d bus info: pci@0000:00:1d.0 version: f1 bredd: 32 bits klocka: 33MHz förmågor: pci normal_decode bus_master cap_list konfiguration: driver=pcieport resurser: irq:16 memory:de400000-de4fffff *-storage beskrivning: Non-Volatile memory controller physical id: 0 bus info: pci@0000:04:00.0 version: 00 bredd: 64 bits klocka: 33MHz förmågor: storage nvm_express bus_master cap_list konfiguration: driver=nvme latency=0 resurser: irq:16 memory:de400000-de403fff
  4. Hi I have a 2016 Dell XPS 9550 with 16GB Ram and 512 GB Nvram SSD. Using the latest version from the github repo with clover and a Sierra installation on a 16GB USB I can get the Mac installation running, but when I try to install or open disk utility then my internal harddrive will not show up. I can only see USB drives. I had a similar problem when installing Ubuntu previously on the same computer, but then went into the BIOS settings and changed over to ACHI from RAID controller for the harddrives. After this the harddrive was detected for the ubuntu installation. On top of that I have disabled secure boot and some other settings. I've also tried other flavors of pre made XPS 9550 Clover configurations without luck (not even being able to launch the MacOS X installation GUI). Does anyone have any hints as to what I need to do in order to trouble shoot this? I'd really like to have Mac running on my Dell computer as my old Mac is on it's last leg.
×