Jump to content
InsanelyMac Forum

valosx86

Members
  • Content count

    29
  • Joined

  • Last visited

About valosx86

  • Rank
    InsanelyMac Protégé

Profile Information

  • Location
    france
  1. valosx86

    [GUIDE] 1st Generation Intel HD Graphics QE/CI

    What is the difference between single and dual link ? I have a working configuration using the single link and my internal LCD (1366x768). now sometime I want to connect an external VGA which is 1920x1400, in which case if I understand, I should use the dual link version ? with the dual link, will my internal LCD work ? if not, how can I switch them at boot time ? thanks
  2. valosx86

    [GUIDE] 1st Generation Intel HD Graphics QE/CI

    Hi there, I have successfully install the kext driver on my laptop (internal LCD 1368x768) but when I connect an external VGA display, Clover setup the correct resolution, my "about this mac" also give me the good one (1920x1400) , but the display is in "overscan" and I need to setup a resolution of 1200x800 to have a correct display ! is there anyway to have the correct resolution ?
  3. valosx86

    [GUIDE] 1st Generation Intel HD Graphics QE/CI

    HI, I have a probook 6450b, it has a core i5 with an intel HD (8086:0046 ;-). I can only boot in safe mode or with intel kext remove. I have try the patch one with single-link, lcd+vga. I use clover. * with clover injection => KP * without injection : work same way as in safe mode : no kext loaded I am on 10.9.2 what can I do/check.
  4. valosx86

    install on probook 6450b

    I am trying to instal lion on a hp probook 6450b I have an old leopard install on external disk which is partially working, but my new lion install continously reboot. it loads all the kext, then reboot ! this installation is working under virtualbox on the same computer ! any ideas ? thanks
×