Jump to content


  • Content count

  • Joined

  • Last visited

About HHR18

  • Rank
    InsanelyMac Protégé

Contact Methods

  • Website URL

Profile Information

  • Gender
  1. HHR18

    Anyone tried with Asus P5B ?

    Have you tried this guide?: http://www.insanelymac.com/forum/index.php?showtopic=256729 After installing the Extra Lion package, I had to move the mach_kernel from the Extra folder to the root of the USB otherwise it would say can't find mach_kernel. It boots just fine, had to use a USB mouse though!
  2. HHR18

    10.6.3 Released !

    Got the same error, will check if I have any of those kexts and see if it works! Did you find a solution yet?
  3. HHR18

    M-Audio AudioPhile 2496, pci soundcard

    So I installed the latest drivers from: http://www.audio-evolution.com/drivers/ And I'm seeing my audiophile 24/96 in the sound control panel but I don't hear any sound? Am I doing something wrong here?
  4. Ok I got my SL working again by going into windows 7, installing MacDrive and replacing the old SleepEnabler.kext with the new one! Gotta love software like MacDrive!
  5. I also get a Kernel Panic because of sleepenabler, is there anyway to boot into my snow leopard partition and replace the old sleepenabler with the new one. USB boot maybe?
  6. HHR18

    Asus P5B motherboard

    Did anyone get snow leopard working with this motherboard?
  7. Hi there, I have a pc with an asus P5B motherboard and a 8800 GTS 640MB videocard. Could anyone recommend me a tutorial that will most likely work on this setup? Thanks in advance!
  8. @Langerak My dell inspiron 1520 has a 1390 WLAN card and this one works out of the box! I also have a broadcom 440x card but I didn't test it yet.
  9. Just installed this on my Dell inspiron 1520 and all went very smooth. Just create partition in vista using command with id=af and stuff. The put the DVD in, booted with platform=X86PC -v -x, installed it, restarted with dvd and used the command to load bootloader. On startup darwin bootloader loads and i used the command platform=X86PC -v and it worked.