Register now to gain access to all of our features. Once registered and logged in, you will be able to contribute to this site by submitting your own content or replying to existing content. You'll be able to customize your profile, receive reputation points as a reward for submitting content, while also communicating with other members via your own private inbox, plus much more! This message will be removed once you have signed in.
rid1 posted a topic in OSx86 10.6 (Snow Leopard)Hello all. I have an HP dv5tse running 32-bit Windows 7 with Intel Core 2 Duo T6400 processor, which is currently running Windows 7 Ultimate brilliantly. I've made a 20 GB unallocated partition using EASEUS Partition Manager, and I'd like to install Snow Leopard on that partition. I'd prefer to install Snow Leopard on the existing setup rather than do a clean install of Snow Leopard and then install Windows. I've made a 16 GB flash drive with an image of the Snow Leopard retail DVD (using TransMac) and ModUSB (installed using Snow Leopard on VMware). However, when I try to boot from this USB, my laptop doesn't recognize it and bypasses it and boots from the hard drive. How can I install Snow Leopard onto this second 20 GB partition? Any info is appreciated. Thanks.
rid1 replied to rid1's topic in Multi-booting and VirtualisationThanks all. Yes, I forgot to mention that I have 3GB RAM, so I'm not expecting lightning fast speeds here. I actually found a Hazard iso for Snow Leopard 10.6.6, and I found directions here: http://www.insanelym...-non-vt-x-cpus/ on how to install it without vt-x (according to my calculations my busratio is 10). So far I've successfully installed it and booted it from the VMware hard drive; however, when I rebooted after it installed, it took me to the Chameleon page, and I still had to type in "-v -f busratio=10 cpus=1" and hit enter to get it to boot properly (takes forever to start up). I also downloaded the darwin_snow.iso file so I could install VMware Tools; it's installing right now. Question: Is there any way to transfer my trackpad scrolling capabilities to VMware? I have a Synaptics TouchPad V6.5 with two-finger vertical and horizontal scrolling.
rid1 posted a topic in Multi-booting and VirtualisationHi, I have an HP dv5tse running 32-bit Windows 7 with Intel Core 2 Duo T6400 processor, which, according to Microsoft Hardware-Assisted Virtualization Detection Tool, does not have hardware virtualization capabilities. I've been searching for a few days with no luck for a way to run Mac OS X through VMware Player or VirtualBox. Since my laptop is 32-bit, I understand that Snow Leopard is the highest I can go (please correct me if I'm wrong). Is there any way at all to run Snow Leopard without hardware virtualization? Any info will be appreciated. Thanks.