Hmm, seems you're experimenting with VirtualSMC rather than FakeSMC and using versions of Lilu + WEG that do not come from the usual Vit9696/acidanthera GitHub's repo where Lilu is up to v1.3.1 and WEG up to 1.2.6.
Where does your setup come from?
If you remove Lilu + WEG, you have to enable "inject nVidia" in your Clover config and possible add "nVidia Single" too.
Yes, you certainly don't have graphics acceleration; now that's normal under Mojave since there is no support for any Intel iGPU older than Ivy Bridge HD4000. You'll have to install the 1st gen Intel HD graphics kexts from previous OS X/macOS versions, knowing that 1st gen graphics have always been subject to conditions. You can refer to the Bible on 1st gen Intel HD graphics.
Hi all, I started working on this pc during last days and finally, it's working.
Intel i3 550 - 3.20Ghz
Graphics: Nvidia GeForce GT 710M. (Integrated works with LiLu + WhateverGreen, but I couldn't get full display resolution).
WiFi: TL-WN727N (rev 03)
Motherboard: MSI 2a9c. (no UEFI)
1) Creating bootable Mojave USB.
To create a Mojave USB installer, I red the apple wiki, works just fine.
2) Installing Clover.
Clover must be installed in Legacy Mode. See the screenshot above for installation.
3) Copying necessary kext into clover and add config.plist.
We will need those kexts (download "kexts" in attachments):
-com.apple.telemetry.plugin (I extracted the kext from high Sierra)
Just copy them into EFI://Clover/kexts/Other/.
Warning: only copy LiLu and WhatEvergreen only if you're booting with integrated graphics.
Now, download config.plist in attachments and replace with clover's default.
Note 1: I used SMBIOS from iMac 13.3 because using 11.2 block the installer, as the iMac 11.2 doesn't officially support Mojave.
You can change it to 11.2 whenever you want post-install.
Note 2: The default boot flags are "-no_compat_check -v".
This allow to boot normally. Without the first bootflag, we should obtain a message that says "This version of MacOS is not supported on this platform".
4) Booting and installing.
Now, just boot and install. I selected Guid partition map and APFS file system.
5) Installing WiFi
just download any version of BearExtender (make sure to follow the instructions in the package) and install the kext RT2870USBWirelessDriver.kext which I attached under "wifi.zip".
6) Installing Audio
To make the audio works, I just installed VoodooHDA. Just pick the last version of it from here and install (I prefer kext utility), then, repair the permissions and reboot.
many thanks to @Baio77 and @Hervé, who helped me during the first phase.
No need for AppleIntelCPUPM patch on an Arrandale PC; that's exclusively for 2nd gen Sandy Bridge and 3rd gen Ivy Bridge platforms.
1st gen graphics are not supported under Mojave so you'll have to wait until you receive the GT710 to get graphics properly running. Make sure you bought a Kepler version of the GT710 because the Fermi version is not supported. At present, Mojave supports Nvidia Kepler cards only (nothing before and nothing after).