Jump to content

ffrlr

Newbies
  • Content count

    5
  • Joined

  • Last visited

About ffrlr

  • Rank
    InsanelyMac Protégé
  1. [Help] Dell Latitude E6400

    Finally got it running, the boot / reboot issue seemed to have been caused by the E6400 having a WWAN card inside, I removed the WWAN card, and it booted up fine. KoliberK, did you have any problem with the screen going completely white after a set time, I have done a bit of testing and it is when the 'energy saver' comes in, if I set it to say 1 minute, then after 1 minute of no computer use, I get a completely bright white screen until I hit a key. The E6400 I have is an intel graphics version if that makes any difference? Tony
  2. [Help] Dell Latitude E6400

    Progress...., repeating the above procedure, seems to have had some effect, the drive when put back in the E6400, now starts to boot, I see the bootloader screen, then after about 5 seconds it crashes, and restarts, this crash / restart loop continues indefinately. If I press spacebar when the bootloader screen is visible, then type -v, I get screen fulls of text scrolling up the screen, but it still crashes and restarts, what else can I try? is it possible to find what caused the crash? Tony
  3. [Help] Dell Latitude E6400

    Guess I have done something wrong somewhere, I have done what I noted above, when the drive is put back in the E6400 (80GB sata drive), when it tries to boot I get boot0: GPT boot0: test boot0: test boot0: done the cursor is flashing but nothing further happens, so I will format the drive and restore the image again using Disk Utility and try again. Tony
  4. [Help] Dell Latitude E6400

    Thanks for the link Koliberk, I doenloaded it from your dropbox. i'll try it this evening when I get home. Am I correct in thinking I connect the E6400 drive attached to the D620 USB via a sata / usb adapter. Then, run Chameleon on the D620 and perform the operations on the E6400 ML drive atttached to the USB? Finally, remove the USB / sata adapter and put the drive back in the E6400 and it should boot ML? Thanks again Regards Tony
  5. [Help] Dell Latitude E6400

    Hi guys Can someone give me a few pointers, I am struggling to get ML running on a Dell E6400. I have downloaded the 10.8.2 OSX image above, copied that to a Dell d620 running SL, then restored it to the drive I took out of the E6400, problem now is it will not boot when put back in the E6400. From reading the posts, I believe I need to install a bootloader on the E6400 drive, but it seems all the links are now dead, could someone (KoliberK perhaps who was kind enough to create the image) give me a clue as to which bootloader I need and where it is available from? and how to install it. I have to say, as yet I have very little MAC knowledge, being a Windows person, I have borrowed the D620 and have to say I am hooked!. any help much appreciated. Regards Tony
×