Been workin' on FCS2 in 10.4.9 on my Hack for quite a while now with no flaws, hitches, etc.

Does it work with Leopard yet? Should I spend an entire weekend findin' out?

I have the Install DVDS cause I purchased the Software, this helped me to avoid any issues with FCS2 in the first place when usin' 10.4.9.

Anyone out there?

yea it will work with leapord, if leapord works on you HAck. which im guessing it will if it works with tiger!
you should be okay. you would only run into some minor problems if any.

Working fine here. No issues.

work just like on my friend s mac pro

working as a beast

What distro are you using for 10.4.9? Uphuck?

Worked on Leo 10.5.2 but slower and more unstable than Tiger(on hack). Reinstalled Tiger.

Hey Khid!

I`ve been folowing all the instructions on this forum for a 1 mounth but no luck to make FCP6 run on mz system.
Dude...1 damn mounth. I just cannot figure it out what is wtong.
I`ve installed FCS2, everything is working (motion,DVD studio,compressor etc) except Final cut.
I have os x 10.4.9 uphuck, Intel pentium 4 (HT) 2 GB RAM, 250 GB SATA, Nvidia quadro FX500/600
(supprts QE, I cannot see rotation...) Gzgabite motherboard wth built-in ethernet(marvel yukon/working perfictly) set as en0, ....I did everzthing else that I found on the forum.....but it just not working. As I sad it`s been a mounth already, can you or someone HELP me please????
Thnx!!!!!
Roz

my Kalyway 10.5.1 updated to 10.5.3 runs well with final cut. so far no problems