Hi.

I've installed OSX on my computer today. everything's working so perfect Except the External SATA port and jmicron's SATA port.

of course the external SATA drive is working just fine on WinXP. (after install the patch)

But in case of OSX, even after I've installed KoolKal's Jmicron Patch, It seems OSX can't find the external SATA drive.

and it doesn't recognize a SATA drive which installed on Jmicron SATA port either. (I don't want to use RAID hard. I just need one more SATA port for single SATA HDD)

So How can I solve this problem?

I set up the BIOS like this

ACHI ==> disable

jmicron mode==> basic (NOT ACHI)

is this right?


And here's my HDD /ODD list

2 seagate 500GB HDD (one for WinXP, one for OSX) & 1 ODD for ICH port (So I'm using full 3 ICH port)

1 seagate 500GB HDD for Jmicron port (not working)

1 external SATA HDD for External SATA port (not working)


mainboard: P5W DH


OSX installation

Jas 10.4.8 -> Jas 10.4.9 -> KoolKal 10.4.10

FCP2 and Motion3 is fully working


Please. someone help...

and sorry for my bad grammar. (i'm not english native)

my e-sata is working fine.I guess some of you´re settings are wrong, but I can´t check it before sunday - your bios version?

version of BIOS is 1901.

thanks.

first of all: I´m using bios 2206

settings

J-Micron Controller

active
ahci

IDE configuration

enhanced mode
s-ata

with those settings my e-sata works perfect - I hope I could help

I had my ICH/intel SATA in AHCI and the jmicron sata ports were working. but my jmicron is set to Basic mode.
Bios 2503.