Ok, ive been toying around with OSX86 for a while now, mainly trying to get my monitor setup just right..finally after playing with just about every permutation i can think of, Ive not only got my fx5700le recognized and have the option of multiple resolutions, but i now also have QE/CI enabled! I basically put in natit, and then edited the plist in geforce/nvdaresman/nvdanv30 kexts..i also eventually dumped my agpgart.kext..

However, right now about this mac sees my card as PCI, when its AGP (it was doing that before i dumped the AGPgart.kext) and it wont see my 2nd monitor, which is fairly essential for my setup..



ive got an INTEL 2.8ghz piv, gig of ram, fx5700le agp card vga/dvi (i use a dvi to vga connector for the 2nd monitor)


i also happen to have another older pci video card, a geforce mx4000 that works fine, i just had some issues with it when i was first getting into OSXing on my PC, so i took it out..but if i could use both cards at the same time, that would be pretty great.


just wondering if anyone has any ideas on what I could do to get this 2nd monitor running! its about the only things stopping me from being osX full time!

There's a sticky thread (on top) of this Natit section where there's instruction for dual display, check it out.

hey....i managed to get my fx5700le enabled wit titan.....did it with iAtkos 10.5.4....did my install and included Titan.....all working fine....in the system profiler is something mentioned about 2nd. screen, but i didn't test it....perhaps compare this output with yours? Seems mine is working!!