Hi all,
I am a new entry. Try to installa Mac Os X86 10.4.6 JaS on my Dell D810 Laptop series. At the end of installation it ask to reboot, but after load AppleACPICPU it display:

panic (cpu 0 caller 0x0019CFFC): commpage no match on last routine

Backtrace, Frame: Return address (4 potential args on stack)

bla bla bla....

Backtrace terminate invalid frame pointer 0x0

Can somebody help me please?!?!

Tnx in advance,

Carlo

Right before you clicked the "Install" button, did you click the "Customize" button and select the right packages for your computer?

If so, what packages?

Hello Rammjet,
I have installed all the components....I think isn't right!

Carlo

NO, you must select components for your computer. Selecting them all will cause boot problems.

Hi,
now the OSX start correctly, but the screen can be set only at 1024x768 and ethernet do not work!
Does exist some drivers for my ATI Mobility and for ethernert card!?!?

Tnx,

Carlo

For ATI Mobility, check out the Callisto drivers:

http://omni.starchaser.org/callisto/

and the patch: http://forum.insanelymac.com/index.php?showtopic=10415

For ethernet, you need to figure out the make and model so that a driver can be found.

Hi Rammjet

thanks for ATI and Boot panic solutions.

Another quest for ethernet, my Dell have a Broadcom NetXtreme 57xx Gigabit....can you help me!?!?

Best regards,

Carlo

Try to determine what the XX really is in the 57XX Gigabit.

Get a beer and read through this:
http://forum.insanelymac.com/index.php?showtopic=4987

Thank you very much Rammjet !

Carlo

Carlo,

I too have a D810 with the exact same issue. What packages did you select (if you can recall). Any help would be greatly appreciated.

Rocket