Jump to content

ryansoh3

ryansoh3

Member Since 08 Dec 2011
Offline Last Active Private
-----

Topics I've Started

DVI-DVI cable works, but DVI-HDMI doesn't on 10.8.x?

15 October 2013 - 01:05 PM

Hi guys and gals,

 

I was wondering what the problem was with my setup.

 

I have an Asus P7P55D with an Asus 9800GT that has two DVI ports.

 

Everything has worked on my 10.8.2 flawlessly via a DVI-DVI cable to a 23 inch monitor. (1680x1050)

 

I recently upgraded my monitor to a 27 inch (1920x1080), and it only accepts HDMI, not DVI. 

 

So when I booted 10.8.2 with the included DVI to HDMI cable, everything goes fine until I get a blank screen and the monitor goes to stand by because it doesn't get a signal.

 

I can confirm that it has successfully booted because the caps lock key lights up when I turn caps lock on.

 

I switched back to my 23 inch monitor temporarily with a DVI-DVI and everything works well again.

 

 

When I attempted to reinstall ML using U**Beast, the same thing happened with the new 27 inch monitor (no signal) but it loaded just fine with the old one.

 

Any help would be appreciated, thanks a lot!

 

PS. I'm using the first PCI-E slot for the GPU and the main DVI port out of the two. I'm using a DSDT.aml extracted via AIDA64.

 

I tried to boot from 10.8.3 and 10.8.5 prepared using #####, but they both didn't fix this issue. 

© 2014 InsanelyMac  |   News  |   Forum  |   Downloads  |   OSx86 Wiki  |   Mac Netbook  |   Web hosting by CatN  |   Designed by Ed Gain  |   Logo by irfan  |   Privacy Policy